1000W ZVS High Frequency Induction Heating Board Module High Power Heat Dissipation Heating PCB Board for Voltage

Feature: 1. PCB Material: The high frequency induction heater is made of 100x100mm military grade PCB with high density and stable performance. 2. High Power: The power line of 1000W induction heating module adopts full copper laying design, which greatly increases the current and generates less heat. 3. Heat Dissipation: Heating PCB board module adopts 100x32x58mm oversized 5 tooth 4 hole high power heat sink for better heat dissipation. 4. High Voltage Output: The output side uses 3 M4 copper columns in parallel, can be connected to other outputs such as high voltage package. 5. 2.54mm Socket: Induction heating board has a 2.54mm socket, after connecting the voltage regulator, plug in the supporting cooling fan and water pump can be used. Specification: Item Type: Induction Heating Board Material: PCB Size: Heating Plate: Approx. 100 x 100mm 3.9 x 3.9in Heat Sink: Approx. 100 x 32 x 58mm 3.9 x 1.3 x 2.3in Input Voltage: 12V 48 Recommended 36V Power Requirements: Less Than 12V more than 10A, More Than 15V more than 15A Current: 20A Power: 1000W . Package List: 1 x Induction Heating Board 1 x Heat Conduction Tube Note: 1. The minimum input voltage of this module is 12V does not mean that all 12V power supply can be used, some novice buyers use a power supply with less power, the specific voltage and current of this module have requirements, voltage 12V current must be more than 10A power supply can be used, the power of the power supply is too low will to the actual output voltage of the power supply when the high power output is greatly reduced, when the voltage is lower than 12V will to two MOS tubes on at the same time, will burn MOS tubes.2. Some buyers will not pay attention to the power requirements of the power supply when using the MOS tube heating, if found MOS tube heating abnormal then first consider whether the power supply output to meet the requirements3. The board should not be idle, otherwise it will make a high frequency noise, and then the MOS tube will heat up and burn out4 induction heating recommended the use of 36V20A power supply, 12V power supply is too small heating almost no response, and 12V power supply heating easily to lower power supply output voltage, below 12V is very dangerous5. Induction heating power is very large, heat is inevitable, be sure to do a good job of heat dissipation.6. Do induction heating should use the copper tube matched with this product, or winding in accordance with the standard of 8 turns with an inner Diameter of 40mm, otherwise the buyer is responsible for any burning problems. 7. Please allow some errors due to manual measurement.