Electronic Thermostat 110-240V Xh-W3001 1500W

Electronic Thermostat 110-240V XH-W3001 1500W Universal regulator, allowing you to control various types of electronic devices. The thermostat can operate in both cooling and heating modes. The regulator will remember the set temperature after disconnecting the power supply. Thanks to you can achieve the desired temperature without manual intervention. The thermostat allows savings. Infinitely many configuration possibilities, for example you can configure it to turn on when the temperature drops below +5°C and turn off when it reaches +8°C It can be used to control: Heaters Water pumps Central heating pumps Fans Fan heaters, fan heaters Compressors Photovoltaics and any other electrical tool whose operation may be temperature dependent. Specification: Input (power supply) voltage: AC 110-230V Temperature measurement: -50°C - +110°C Maximum relay load current: 1500W / 7A Thermostat operating temperature: -5°C to - +40°C Temperature measurement resolution: 0.1°C (up to 99.9°C) Temperature refresh rate: 0.5s Sensor used: NTC10K (waterproof) Probe diameter: 5mm Probe length: 25mm Material: stainless steel Temperature measurement probe: waterproof Cable length with probe: 100cm Length of other cables: 8-10cm Display: LED 3 digits Color display: red Housing dimensions without mountings: 60 x 45 x 31 mm Mounting hole spacing: 73 mm 1⃣ Power supply 220V Red wire: power supply (black - neutral). 2⃣ 220V output Yellow wire: receiver whose operation is to be controlled by the thermostat (black - neutral). 3⃣ Probe Programming: Setting the temperature that turns on the device connected to the controller (start): Hold down the button for 3 seconds to start the temperature edit mode - the screen should start flashing. During the edit mode, you can set the desired temperature using the and buttons . After setting the temperature, do not touch the buttons for 3 seconds to save the set temperature. Setting the temperature that turns off the device connected to the controller (stop): Hold down the button for 3 seconds to start the temperature edit mode - the screen should start flashing. During edit mode, you can set the desired temperature using the and buttons. After setting the temperature, do not touch the buttons for 3 seconds to save the set temperature. To check the set switch-on temperature (start) or target temperature (stop), press the or button once. START activation temperature lower than STOP deactivation temperature - HEATING MODE START activation temperature higher than STOP deactivation temperature - COOLING MODE. Description: 1⃣ Current temperature 2⃣ Up regulation 3⃣ Input 4⃣ Output 5⃣ Temperature sensor 6⃣ Down regulation 7⃣ Output indicator